QTP Aggressor Bolt-In Electric Exhaust Cutout Pipes - Dodge Durango 5.7L

A cutout gives you two exhausts in one system. Valve shut, the car stays factory-quiet. Valve open, exhaust dumps ahead of the muffler and you get the volume and the flow. The problem has always been the install: working out where the pipe goes, what it clears, and how much fabrication it needs.

The Aggressor removes that problem. It is a vehicle-specific cutout pipe kit, CAD-modelled for this application, so the routing and the hanger locations are already sorted. Most kits need no welding at all. Cut, clamp, wire, done.

QTP pioneered electronically controlled exhaust more than twenty years ago and builds every valve in house. The pipe is 304 stainless steel.

Features

• Vehicle-specific routing, no custom fabrication or guesswork on install location
• QTEC electronic valve with full control over volume and back pressure
• Valve holds any position between fully closed and wide open
• 304 stainless steel construction
• Uses factory hanger locations
• Made in the USA

Specifications

• Type: Bolt-in electric exhaust cutout pipe kit
• Material: 304 stainless steel
• Control: Dual-position momentary switch. Wireless remote sold separately
• Engine: 5.7L

In the Box

• Aggressor cutout pipe kit
• QTEC electronic valve or valves as required
• Wiring harness
• Dual-position momentary switch
• Hardware, gaskets and instruction sheet

Not designed or intended for use as a catalytic converter, DPF or EGR delete. Check local noise and emissions regulations before fitting.